Kohler Courage SV710-740 Service Manual page 130

4. Route the stator leads in the crankcase recess,
then install the backing plate. Secure with
the four hex flange screws. See Figures 10-32
and 10-33. Torque the screws in the indicated
sequence to 7.3 N·m (65 in. lb.).
NOTE: Before installing the flywheel, make sure the
crankshaft taper and flywheel hub are clean,
dry, and completely free of lubricants. The
presence of lubricants can cause the flywheel
to be overstressed and damaged when the
flange screw is torqued to specifications.
1. Install the woodruff key into the keyway of the
crankshaft. Make sure that the key is properly
seated and parallel with the shaft taper. See
Figure 10-34.
NOTE: Make sure the flywheel key is installed
properly in the keyway. The flywheel
can become cracked or damaged if the
key is not installed properly.
2. Install the flywheel onto the crankshaft being
careful not to shift the woodruff key. See Figure
10-36.