Kohler Courage SV710-740 Service Manual page 89

7. Install the backup washer, followed by the rubber
grommet, into the matching recess of the drive
end cap. The molded recesses in the grommet
should be out, matching and aligned with those
in the end cap. See Figure 7-58.
8. Install the frame, with the small notch forward,
onto the armature and drive end cap. Align the
notch with the corresponding section in the
rubber grommet. Install the drain tube in the rear
cutout, if it was removed previously. See Figure
7-59.
9. Install the flat thrust washer onto the commutator
end of the armature shaft. See Figure 7-60.
10. Starter reassembly when replacing the Brushes/
Brush Holder Assembly:
a. Hold the starter assembly vertically on the
end housing, and carefully position the
assembled brush holder assembly, with the
supplied protective tube, against the end of
the commutator/armature. The mounting
screw holes in the metal clips must be up/out.
Slide the brush holder assembly down into
place around the commutator, and install the
positive (+) brush lead grommet in the cutout
of the frame. See Figure 7-61. The protective
tube may be saved and used for future
servicing.
Starter reassembly when not replacing the Brushes/
Brush Holder Assembly:
a. Carefully unhook the retaining caps from
over each of the brush assemblies. Do not lose
the springs.