Kohler Courage SV710-740 Service Manual page 90

b. Position each of the brushes back in their slots
so they are flush with the I.D. of the brush
holder assembly. Insert the Brush Installation
Tool with extension, or use the tube described
above from a prior brush installation, through
the brush holder assembly, so the holes in the
metal mounting clips are "up/out."
c. Install the brush springs and snap on the four
retainer caps. See Figure 7-63.
d. Hold the starter assembly vertically on the
end housing, and carefully place the tool
with extension) and assembled original brush
older assembly onto the end of the armature
shaft. Slide the brush holder assembly down
into place around the commutator, install the
positive (+) brush lead grommet in the cutout
of the frame. See Figure 7-64.
11. Install the end cap onto the armature and frame,
aligning the thin raised rib in the end cap with
the corresponding slot in the grommet of the
positive (+) brush lead.
12. Install the two thru bolts, and the two brush
holder mounting screws. Torque the thru bolts
to 5.6-9.0 N·m (49-79 in. lb.). Torque the brush
holder mounting screws to 2.5-3.3 N·m
(22-29 in. lb.). See Figures 7-65 and 7-66.