Section 10. Reassembly - Kohler Courage SV710-740 Service Manual

Governor Assembly (Internal)
Inspection
Inspect the governor gear teeth. Replace the gear if it
is worn, chipped, or if any teeth are missing. Inspect
the governor weights. They should move freely in the
governor gear.
Disassembly
The governor gear must be replaced once it is
removed from the oil pan.
NOTE: The governor gear is held onto the shaft by
small molded tabs in the gear. When the
gear is removed from the shaft, these tabs
are destroyed and the gear must be replaced.
Therefore, remove the gear only if absolutely
necessary.
1. Use two small screwdrivers and carefully pry
upward to remove the regulating pin and
governor gear assembly. See Figure 9-13.
Figure 9-13. Removing Governor Gear.
2. Remove the locking tab thrust washer located
under the governor assembly.
3. Carefully inspect the governor gear shaft and
replace it only if it is damaged. After removing
the damaged shaft, press or lightly tap the
replacement shaft into the closure plate to the
depth shown in Figure 9-14.
Inspection and Reconditioning
34.0 mm (1.3386 in.)
33.5 mm (1.3189 in.)
Figure 9-14. Governor Shaft Press Depth.
Reassembly
1. Install the locking tab thrust washer on the
governor gear shaft with the tab down.
2. Position the regulating pin within the governor
gear/flyweights assembly and slide both onto
governor shaft until assembly locks into place.
See Figure 9-15.
Figure 9-15. Installing Thrust Washer, Regulating
Pin and Governor Gear Assembly.
Oil Pump Assembly
Disassembly
1. Remove the two hex flange screws. See Figure
9-16.
2. Lift the oil pump assembly from the oil pan. See
Figure 9-17.
Section 9
Gear Shaft
19.40 mm (0.7638 in.)
Thrust
Washer
(Tang
Down)
9.11
9