Kohler Courage SV710-740 Service Manual page 146

5. Add oil to bring the level up to the F/Full mark.
Turn the oil fill cap/dipstick counterclockwise
until the oil fill cap drops down to the lowest
point of the thread leads. Do not thread the oil fill
cap onto the tube. See Figure 10-87 and 10-88. The
oil level needs to be within the operating range.
See Figure 10-89. If low, add oil of the proper
type up to the full mark. If oil is above F or FULL
mark, drain oil to reach proper level. Reinstall the
oil fill cap/dipstick and thread until tight.
1. Connect the leads to the spark plugs. See Figure
10-90.
The engine is now completely reassembled. Before
starting or operating the engine, be sure to do the
following.
1. Make sure all hardware is tightened securely.
2. Make sure the oil drain plug, oil sentry pressure
switch, and a new oil filter are installed.
3. Fill the crankcase with the correct amount,
weight, and type of oil. Refer to oil
recommendations and procedures in Section 1,
Safety and General Information and Section 6
Lubrication System.
4. Adjust the carburetor idle fuel needle, or idle
speed adjusting screw as necessary. Refer to
Section, 5 Fuel System and Governor.
It is recommended that the engine be operated on a `
stand or bench prior to installation in the piece of
equipment.
1. Run the engine at idle for 2-3 minutes, then 5-6
minutes more between idle and midrange. Adjust
the carburetor mixture setting as necessary.
2. Adjust the idle speed screw and high-speed stop
as necessary. Make sure the maximum engine
speed does not exceed 3750 RPM (no load).