Kohler Courage SV710-740 Service Manual page 126

4. If the camshaft endplay is not within the specified
range, remove the endplay tool and shim
accordingly. See Figure 10-17. Shims are color-
coded by thickness and listed below.
White: 0.69215/0.73025 mm (0.02725/0.02875 in.)
Blue: 0.74295/0.78105 mm (0.02925/0.03075 in.)
Red: 0.79375/0.83185 mm (0.03125/0.03275 in.)
Yellow: 0.84455/0.88265 mm (0.03325/0.03475 in.)
Green: 0.89535/0.99345 mm (0.03525/0.03675 in.)
Gray: 0.94615/0.98425 mm (0.03725/0.03875 in.)
Black: 0.99695/1.03505 mm (0.03925/0.04075 in.)
5. Reinstall the endplay tool and recheck the end
play.
The oil pump is mounted inside the oil pan. If service
was required, and the oil pump was removed, refer to
the assembly procedures in Section 9, Inspection and
Reconditioning.
The governor assembly is located inside the oil pan. If
service was required, and the governor was removed,
refer to the assembly procedures in Section 9,
Inspection and Reconditioning.
1. Check to make sure that there are no nicks or
burrs in the crankshaft bore of the oil pan.
2. Apply a light coat of engine oil to the outside
diameter of the oil seal.
3. Drive the oil seal into the oil pan using a seal
driver. Make sure the oil seal is installed straight
and true in the bore, to the depth shown in
Figures 10-18.
1. Lubricate new O-rings with clean oil and install
into the groove on the ends of the oil pump
transfer tube. See Figure 10-19.
2. Install the transfer tube with the O-rings. Push
in until seated into the outlet of oil pump. Make
sure the inner O-ring is not unseated or damaged
when installing. See Figure 10-20.