BEOVISION Avant DVD Reference Book page 8

8
Completing connections
When you set BeoVision Avant up on its own,
simply connect the aerial and connect the
system to the mains. If you wish to connect
any other equipment, please refer to the
chapters on connections as well as Register
extra equipment on page 20.
>> Setting up your BeoVision Avant
BeoVision Avant
Aerial connection
Using an aerial cable, connect your external
aerial (or a cable TV network) to the socket
marked VHF/UHF on the BeoVision Avant rear
socket panel.
Mains connection
Using the mains cord supplied, connect one
end to the socket marked ~ on the rear of the
BeoVision Avant, then plug the other end into
a wall socket.
Your BeoVision Avant was designed to be left
in stand-by mode when not in use. Therefore,
to facilitate remote control operation, etc., it
is essential that you leave the mains switch
on, once you have turned it on.
However, if you are going to connect speakers,
an audio system or any other equipment to
BeoVision Avant, do not switch on at the mains
yet!
Stand-by indicator
After you connect and fasten the cables as
explained on the previous page, you can connect
Avant to the mains. Switch on the mains switch
on the front of BeoVision Avant. A tiny, red light
appears in the display panel. The system is in
stand-by mode and ready to be used. If your
Avant is set up on its own, you can now start to
use it as explained in the chapter 'Watch
television' on page 6 in the Guide.
Mains switch