Table of Contents
Advertisement
6
We recommend that you follow the
procedure described below when
you set up your BeoVision Avant:
– Unpack the BeoVision Avant and
place it as described and
illustrated to the right;
– Consider the appropriate
surroundings for your Avant.
Guidelines are included to the
right;
– Mount the base plate as
described;
– Connect the cables, additional
equipment, and speakers as
described in the following
chapters. For information of how
to fasten and run the cables on
the rear of BeoVision Avant, refer
to the opposite page.
For an overview of the display, close-
up operation and socket panels, refer
to the opposite page and the
chapters The display bar, page 51,
The socket panels, page 56 and
Close-up operation panel, page 58.
Set up your BeoVision Avant
Handling your BeoVision Avant
Due to the weight of the BeoVision Avant,
any moving/lifting of the system should
always be done by two persons.
The BeoVision Avant has three sets of recesses
for lifting the system. The illustrations show
the placement of each recess (A, B and C).
Do not attempt to lift the BeoVision Avant holding
on to any other parts of the cabinet or rear panel!
Placing your BeoVision Avant in
your home
– Avoid placing your BeoVision Avant in direct
sunlight or direct artificial light (e.g. a spotlight),
as this may reduce the sensitivity of the remote
control receiver.
– Make sure that the BeoVision Avant is set up,
placed and connected in accordance with this
guide.
– The BeoVision Avant is developed for indoor
use in dry, domestic environments only, and for
use within a temperature range of 10–40ºC
(50–105ºF).
– Do not place any items on top of the BeoVision
Avant.
– Do not attempt to open the BeoVision Avant.
Leave such operations to qualified service
personnel.
– The motorised stand will turn the BeoVision
Avant to a preset position when you switch it
on.
C
A
A
B
B
C
C
B
B
Leave enough space around the TV to allow it to
turn freely. The television can also be turned by
A
B
hand.
Advertisement
Table of Contents
