BEOVISION Avant DVD Reference Book page 19

Connections
Your BeoVision Avant in the link room must
be connected to your main room system using
two different cables:
– BeoLink connection (using a Master Link
cable and a junction box).
– Aerial connection (using an ordinary aerial
cable).
BeoLink connection
In the main room: Connect the Master Link cable
to the socket marked MASTER LINK on the
main system. Run the cable to the junction box,
and cut the cable to an appropriate length.
In the link room: Connect the Master Link cable
to the socket marked MASTER LINK on the
BeoVision Avant. Run the cable to the junction
box, and cut the cable to an appropriate length.
Inside the junction box: Join the cables as
explained in the folder enclosed with the
box/cable. This folder explains all the
possibilities for the box, and how to join the
cables.
Aerial connection
Using an ordinary TV aerial cable (coaxial cable),
connect one end to the socket marked LINK on
the main system, and the other end to the aerial
input socket on the link room TV.
Link frequency
If a TV channel is broadcasting on the same
frequency that the main room system uses to
send video to the link room (set from the
factory to 599 MHz), you may need to adjust
the main room system's video transmission
frequency.
Tuning
1 TV
2 Sat
3 Link frequency
Frequency
599
When the connections are complete, you can
begin tuning in the TV channels in your area,
presetting the sound and picture levels, etc., as
described on the following pages.
> Press MENU to call up the main menu.
> Press 3 to call up the Setup menu (4 if Sat is
available).
> Press GO to call up the Tuning menu.
> Press 2 to call up the Link frequency menu (3 if
Sat is available).
> Press or to find an available frequency.
▲ ▼
Alternatively, key in the frequency, e.g. 599,
using the number keys on the Beo4 remote
control.
> Press GO to store your setting, or EXIT to leave
all menus.
19