Table of Contents
Advertisement
If you connect a set-top box to
BeoVision Avant and wish to control
it with your Beo4, your television
must be equipped with the Set-top
Box Controller module.
You can connect a set-top box to the
DECODER, AV or V.TAPE sockets on
BeoVision Avant. You can also
connect two set-top boxes, but only
if your BeoVision Avant is not
equipped with the built-in satellite
receiver module.
Furthermore, you can connect a
second set-top box to BeoVision
Avant via the CamCorder socket. For
more information, refer to the
chapter The socket panels on page
56.
Make sure that all connected
equipment is registered in the
Connections menu. Refer to the
chapter Register extra equipment on
page 20 for further information.
Connect a set-top box
Set-top box (SAT or V.AUX)
AV
connection
IR transmitter
connection
BeoVision Avant
AV connection
Disconnect all involved systems from the mains
before you connect external equipment. Use
the 21-pin AV cable to connect the set-top box
to your BeoVision Avant:
> Connect one end to the set-top box.
> Run the cable to the AV, DECODER or V.TAPE
socket on the back of BeoVision Avant.
IR transmitter
In order to enable remote control operation of
your set-top box with the Beo4 remote
control, you must connect the enclosed low-
power IR transmitter:
> Connect the IR transmitter to the IR OUTPUT
socket on BeoVision Avant.
> Fasten the IR transmitter to the IR receiver of the
set-top box (please follow the instructions
enclosed with the IR transmitter).
To be able to use the remote control included with
your set-top box, do not cover its IR receiver
entirely.
Secondary set-top box
STB (V.AUX)
Primary set-top box
STB (SAT)
IR transmitter
connections
If you connect two set-top boxes...
You will need an IR Y-adaptor (index number
6174171) to connect two set-top boxes to your
BeoVision Avant. Please contact your Bang &
Olufsen retailer. Follow the procedure described
below to connect two set-top boxes to BeoVision
Avant:
> Connect your primary and secondary set-top
boxes to the AV and DECODER sockets on
BeoVision Avant (or the DECODER and V.TAPE
sockets if you have connected equipment to the
AV socket) via 21-pin AV cables as shown.
> Connect the IR Y-adaptor to the IR OUTPUT
socket on BeoVision Avant.
> Connect the IR transmitter for your primary
set-top box to the chrome socket on the IR
Y-adaptor, and fasten the other end to the IR
receiver on your primary set-top box.
> Connect the IR transmitter for your secondary
set-top box to the gold socket on the IR
Y-adaptor, and fasten the other end to the IR
receiver on your secondary set-top box.
> Register your primary set-top box in the
Connections menu as STB (SAT) and your
secondary set-top box as STB (V.AUX). Refer to
the chapter Register extra equipment for further
instruction.
13
Advertisement
Table of Contents
