Table of Contents
Advertisement
20
If you connect additional video sources
or equipment to your BeoVision Avant,
then you must register the equipment
in the Connections menu.
The Connections menu registers what is
connected to the sockets on the rear of
BeoVision Avant.
For information about where and how
to connect extra equipment, please
refer to the chapters on connections as
well as The socket panels on page 56.
Register extra equipment
Registering the equipment connected to
BeoVision Avant enables you to operate it
with the Beo4 remote control.
Setup
1 Tuning
2 Sound
3 Picture
4 Stand
5 Connections
6 Menu
7 Clock
V. Tape
AV
V.Tape
None
> Switch on the system and press MENU to call
up the main menu.
> Press 3 to call up the Setup menu (4 if Sat is
available).
> Press 5 to call up the Connections menu.
> The three main sockets for extra equipment,
V.Tape, AV and Decoder, are shown, as well as
the default settings for those sockets, V.Tape,
None and Decoder.
tt
> Press
to select a socket.
> Press
or
▲
▼
Decoder
available equipment types until you find what
Decoder
you have connected. Select None if nothing is
connected.
> When you have selected your equipment types,
press GO to store your settings or press EXIT to
leave all menus.
A single source type, such as a video tape
recorder, can not be registered twice in the
Connections menu, with the exceptions of two
decoders or two set-top boxes. See the chapters
'Connect a set-top box' and 'Connect a decoder'
on pages 13-14 for further information.
to step through the list of
Advertisement
Table of Contents
