BEOVISION Avant DVD Reference Book page 59

Copy from a CamCorder
If you have connected e.g. a BeoCord V 8000
video tape recorder to your BeoVision Avant,
and you connect your CamCorder to the
close-up sockets on the back of the BeoVision
Avant display panel, you can copy CamCorder
recordings onto a videotape. While the tape is
being copied, you can watch a TV programme
or switch off BeoVision Avant entirely.
To copy a recording from a CamCorder...
Connect your CamCorder to BeoVision Avant and
start playback of a CamCorder recording.
RECORD Press to prepare BeoVision
Avant for recording
RECORD Press again to start recording
V TAPE Press V TAPE and then STOP to
STOP pause a recording
RECORD Press to resume a paused
recording, or...
TV ...press a source button, such
as TV, to stop a recording
entirely
*NOTE! If a Set-top Box Controller is built into
your BeoVision Avant, you may connect the
set-top box to either the DECODER, AV or V.TAPE
socket. Which socket to choose depends on the
other equipment you have connected.
Connect a set-top box
If the AV, DECODER or V.TAPE sockets are all
in use, and you would like to connect a
second set-top box, you can connect the
second set-top box to the close-up socket
panel on the back of the Avant display bar.
Setup
1 Tuning
2 Sound
3 Picture
4 Connections
5 Menu
6 Clock
Camcorder
STB (SAT)
Even though you register a set-top box to your
CamCorder sockets, you can still connect a
CamCorder to the sockets on a temporary basis,
without changing settings in the Connections
menu.
If you connect a set-top box to the CamCorder
socket...
> Switch on the system and press MENU to call
up the main menu.
> Press 3 to call up the Setup menu (4 if Sat is
available).
> Press to move the cursor down to
▼
Connections.
> Press MENU. Connections changes to
CamCorder.
> Press GO to call up the CamCorder menu.
> Press or to view your options. Select
▲ ▼
STB(V.AUX) if your BeoVision Avant is equipped
with a built-in satellite receiver, and STB(SAT) if it
is not. You can, of course, select CamCorder if
you have connected a CamCorder to the
close-up sockets. Press GO.
> When you have registered your set-top box, you
will be asked to select your set-top box type
from an on-screen list. Please refer to 'Register
extra equipment' for further information.
> When you have selected your STB type, press
GO to store the settings, or press EXIT to leave
the menu.
You can gain access to a set-top box connected to
the CamCorder socket in one of two ways. If your
set-top box is registered as STB(SAT), press SAT on
Beo4. If it is registered as STB(V.AUX), press LIST
until V.AUX* is shown, and then press GO.
*NOTE! In order for CAMCORD or V.AUX to be
shown in the Beo4 display, they must first be
added to the Beo4 list of functions. See Gain
access to extra functions via Beo4 on page 34 for
further instruction.
59 59