BEOVISION Avant DVD Reference Book page 18

18
If you have a BeoLink distribution
system installed, you can either use
your BeoVision Avant in the main
room, such as a living room, or in a
link room, such as a study or
bedroom.
If you choose to use your BeoVision
Avant in a link room, you can sit in
the link room and enjoy not only all
the BeoVision Avant features, but
also audio or video from the main
room.
You can, for example, listen to radio
programs from a main room
audio system on your link room
BeoVision Avant or watch a
videotape played on a main room
video tape recorder.
Set up BeoVision Avant in a link room
Before you start...
If you choose to use your BeoVision Avant in a
link room, the setup procedure differs from
setup of a stand-alone BeoVision Avant. The
differences are outlined below. You must
follow the procedure described below when
you connect your BeoVision Avant for use in a
link room:
1 Connect the system to the mains;
2 Using the Beo4 remote control, program the link
room BeoVision Avant to Option 6* as described
below;
3 Disconnect BeoVision Avant from the mains;
4 Make the connections described on these pages;
5 Reconnect BeoVision Avant to the mains.
Program BeoVision Avant for link room use
> Hold the • button down on Beo4 while pressing
LIST.
> Release both buttons.
> Press LIST repeatedly until OPTION? is shown in
the Beo4 display and press GO.
> Press LIST repeatedly until V.OPT is shown in the
Beo4 display and press 6*.
Main room Link room
For your entire system to function properly, it is
essential that the BeoVision Avant in the link
room is programmed to the correct Option
before you connect it to the system in the main
*NOTE! If you connect BeoVision Avant for use
in a link room where other link systems are
already connected, such as loudspeakers, then
you must program BeoVision Avant to Option 5
Option 6
room!
instead.