BEOVISION Avant DVD Reference Book page 57

SAT. ANT. 2
Aerial connection for a second LNB (outdoor
dish number two).
ATTN. ON/OFF
Aerial signal attenuator. Options are:
OFF: Normal setting
ON: Signals damped
IR OUTPUT
For connection of a set-top box. (Only
available if a Set-top Box Controller is built
into your BeoVisionAvant DVD).
~
Connection to the mains.
The close-up socket panel
PHONES
You can connect stereo headphones to the
socket marked PHONES. The BeoVision Avant
speakers can then be cut out by pressing the
Beo4 volume button in the middle.
L R VIDEO
The sockets marked L, R, and VIDEO are for
connection of a video camera. LR sockets: For
audio connection (left and right respectively).
VIDEO socket: For the video signal.
S-VHS socket
For the connection of S-VHS or Hi-8
CamCorders only. To watch your CamCorder
recordings on the BeoVision Avant, connect
the camera and switch the BeoVision Avant
on by pressing, e.g. the TV button on the
Beo4 remote control. Then, when you start
playback on your camera, the BeoVision Avant
automatically registers the signal and you can
see the pictures from the CamCorder on the
screen.
If the signal from the CamCorder is switched off
(accidentally), you must press LIST on Beo4 until
CAMCORD* is shown in the Beo4 display and
press GO.
PHONES L R VIDEO
*NOTE! In order for CAMCORD or V.AUX to be
shown in the Beo4 display, they must first be
added to the Beo4 list of functions. See Gain
access to extra functions via Beo4 on page 34 for
further instruction.
57 57
S–VHS