BEOVISION Avant DVD Reference Book page 17

The BeoLink system makes it possible
to distribute picture and/or sound to
other rooms throughout the house.
You can connect your BeoVision
Avant in e.g. the living room to
another video system or set of
speakers in another room, thereby
making it possible to 'move' picture
or sound to other rooms.
Distribute sound and pictures with BeoLink
Link systems throughout your home
The link room system must be connected via a
Master Link cable to the system in the main
room.
> Connect the Master Link cable to the socket
marked MASTER LINK on BeoVision Avant.
> If you want to distribute video signals as well,
connect an ordinary aerial cable to the socket
marked LINK on BeoVision Avant. Then run both
cables to the link room and follow the
instructions enclosed with the link room
equipment.
> If the Master Link socket on the BeoVision Avant
already has an audio system connected, you
must split the Master Link cable in two and join
them with the cable from the link room using a
special junction box. Please consult your Bang &
Olufsen retailer for assistance.
The system modulator
The system modulator ensures that TV signals
can be sent to a connected television in a link
room. Under special circumstances, it may be
necessary to enter modulator settings:
– If your link room is an audio setup, e.g. a BeoLink
Active/Passive, and you choose to set up a non-
linkable TV as well, you must set the system
modulator to On, as described to the right (the
factory setting is Off, which must be used if you
are using a linkable Bang & Olufsen TV).
– If, for example, a TV channel in your area is
broadcasted at the same signal frequency the
BeoLink system uses, 599 MHz, you must tune
the system modulator to an unoccupied
frequency, as described in the following chapter
under Link Frequency.
BeoVision Avant
LINK
MASTER
LINK
Tuning
1 TV
2 Sat
3 Modulator
Modulator
On
To switch on the BeoVision Avant system
modulator...
> Switch on the system and press MENU to call
up the main menu.
> Press 3 to call up the Setup menu (4 if Sat is
available). Tuning is already highlighted.
> Press GO to call up the Tuning menu.
> Press to move the cursor down to the
▼
Link frequency menu.
> Press MENU to reveal the item Modulator.
> Press GO to call up the Modulator menu.
> Press or to change from Off to On.
▲ ▼
> Press GO to store the setting, or EXIT to leave
all menus.
17