BEOVISION Avant DVD Reference Book page 14

14
The connections described on this
page assume a setup with an AV
decoder (a baseband decoder, e.g.
Canal+, or a MAC decoder, etc.) and
BeoVision Avant.
It is possible to connect a decoder to
both the DECODER and AV socket
on BeoVision Avant.
Regardless of the setup you choose,
you must register it in the
Connections menu.
Please refer to the chapter Register
extra equipment on page 20 for
further information about connection
and registration of external
equipment.
NOTE! If your decoder has two 21-pin sockets, it
is important that you use the socket intended for
a video tape recorder and not the socket which
may be marked TV!
Connect a decoder
BeoVision Avant
Connect an AV or RF decoder
To connect an AV decoder (a baseband
decoder, e.g. Canal+, or a MAC decoder, etc.),
connect the cable from the aerial to the
BeoVision Avant. Connect the AV decoder to
the 21-pin socket marked DECODER on the
BeoVision Avant.
If you wish to connect an RF decoder, then
remember to connect the external aerial cable
to the decoder input socket and then forward
the signal or cable to the BeoVision Avant
aerial socket (marked VHF/UHF). Connect the
RF decoder to the 21-pin socket marked
DECODER on the BeoVision Avant.
Once the decoder is registered in the
Connections menu...
> Find an empty channel in the TV list, where you
want the decoded programs to be located.
> Select a TV channel with a 24–hour transmission
(e.g CNN).
> Call up the TV Tuning menu.
> Call up the Manual tuning menu.
> Change the program number (Pr) to the channel
number you decided to place decoded
programs on.
> Move the cursor to More and press GO.
> Move the cursor to Decoder and change the
setting to ON.
> Press EXIT to leave all menus.
Select this stored program number when you want
to watch your decoded programs.
Decoder 1
Decoder 2
Connect two decoders
If you connect two decoders to BeoVision
Avant, connect your primary decoder to the
DECODER socket and your secondary decoder
to the AV socket on BeoVision Avant.
The decoder you connect to the AV socket in this
case must not be a MAC or baseband decoder!