Before Installing Internal Options - Fujitsu Primergy BX620 S4 User Manual

Chapter 7 Installing Internal Options

7.1 Before Installing Internal Options

The following types of internal options can be installed on this Server Blade.
CPU
Expansion card slot module
136
Expansion board
Internal hard disk units
• When installing or removing internal options, make sure to remove the Server
Blade from the Chassis. Failure to do so may cause electric shock.
For details on how to remove the Server Blade from the Chassis, refer to
"BX600 S3 Blade Server System Unit Hardware Guide".
• Do not install unauthorized third party internal options. Doing so may cause a
device failure, fire, or electric shock.
• Do not damage or modify internal cables or devices. Doing so may cause a
device failure, fire, or electric shock.
• The internal components such as the radiation fin remain hot just after the
Server Blade was removed from the Chassis. When installing or removing
internal options, turn the Server Blade off, and wait for a while to begin
operations. In the array system configuration (RAID1), you can replace the
internal hard disk unit without turning the power off.
• The circuit boards and soldered parts of internal options are exposed. They
can be damaged by static electricity. Before handling them, first touch a metal
part of the Chassis to discharge static electricity.
• Do not touch the circuitry on boards or soldered parts. Hold the metallic areas
or the edges of the circuit boards.
• If devices are installed using the methods other than those outlined in this
chapter or disassembled, the warranty will be invalidated.
Memory modules