Fujitsu Primergy BX620 S4 User Manual page 25

When the following operations are performed, the same function as the maintenance switch
can be used.
1. Press the KVM select switch for 5 seconds or longer and release it.
The KVM select LED is lit.
2. Press the KVM select switch again within 3 seconds, and wait for 5 seconds or longer
before release it.
The NMI function can be used.
f KVM select LED ( )
It is lit or blinks depending on the KVM status as follows.
LED status
Off
Lights green
Blinks amber
Blinks green-amber
g Server blade power switch
Press this switch to turn the Server Blade on.
For how to turn on/off, refer to the "BX600 S3 Blade Server System Unit Hardware Guide".
When the hard disk access display LED lights, do not turn off the power. Data in the hard disk
may be damaged.
h Server blade power LED ( )
It is lit or blinks depending on the Server Blade power status as follows.
LED status
Off
Lights green
Lights amber
Blinks green
Blinks amber
Blinks green-amber
PRIMERGY BX620 S4 Server Blade User's Guide
table: KVM select LED
KVM is not selected.
KVM is selected.
Blinks when a BMC error was detected without KVM selected, or when
the maximum installable number for the Server Blades was exceeded.
In this case, contact an office listed in the "Contact Information" of "Start
Guide" or device administrator.
Blinks when a BMC error was detected with KVM selected, or when the
maximum installable number for the Server Blades was exceeded.
In this case, contact an office listed in the "Contact Information" of "Start
Guide" or device administrator.
table: Server blade power LED
The power is not supplied to the Server Blades.
(The Chassis power is not turned on.)
The power is turned on.
The power is turned off. (Standby)
Blinks when an error is detected in the Server Blade or the Server Blade
identification function is used while the power is turned on.
If an error occurs, contact an office listed in the "Contact Information" of
"Start Guide" or device administrator.
Blinks when an error is detected in the Server Blade or the Server Blade
identification function is used while the power is turned off.
If an error occurs, contact an office listed in the "Contact Information" of
"Start Guide" or device administrator.
Standby mode. (ACPI function)
The Server Blade does not support this mode.
Description
Description
25