Creating A Vlan - Fujitsu Primergy BX620 S4 User Manual

Chapter 5 Operations after OS Installation
• You can only set ten or less VLANs to a LAN port.
• For Windows Server 2003, configure maximum four VLANs that enable NetBIOS over TCP/IP in
the entire system.

■ Creating a VLAN

Follow the steps below to create a VLAN.
1
Log on to the Server Blade with administrator privileges.
2
Set the port of the Switch Blade connected to each LAN port or the port of an
external switching hub, so that a VLAN tag frame can be transferred.
3
Click [Start] – [Settings] – [Control Panel] – [Intel
®
Intel PROSet.
4
Select a LAN adapter to set up a VLAN and right-click it.
A VLAN cannot be set to an adapter composing a team.
5
Click [Add VLAN].
6
Specify [ID] and [Name]. Then click [OK].
The [ID] should be identical with the switch setting. The allowable range is 1 to 4094.
The [Name] does not need to be identical with the switch setting.
When the confirmation message appears, select [Yes].
7
Repeat Steps 4 through 6 to set respective VLANs.
8
Click [OK] to exit Intel
When configuring a VLAN is completed, a virtual adapter "Intel(R) Advanced Network Services
Virtual Adapter" will appear.
Upper protocols will be bound with this virtual adapter.
You cannot bind them with the LAN card consisting a team.
The IP address should be specified in this virtual adapter.
9
Restart the Server Blade.
124
®
PROSet.
®
PROSet Wired], and start