Download Print this page

Star Trac E-UB Installation Instructions Manual page 49

Hide thumbs Also See for E-UB:

Step 29.

Now take the 5" silicon wrap from the kit and

peel off its protective tape then wrap the two

connectors so that all of the metal surface is

covered.

Step 31.

Plug-in the 12-pin main I/O cable coming from

the unit base into the front display circuit board

at J4 connector.

Tie Wrap

Step 30.

Using a 5" tie wrap from the PVS kit, bind the

cables from the PVS neck to one side of the

display mount. Take the tie and put it through

the hole on one of the display mount tubes.

Step 32.

Next, plug-in the heart rate cable from the neck

into the heart rate board connector on the dis-

play.

620-7922 Rev B