Star Trac E-UB Installation Instructions Manual page 17

Hide thumbs Also See for E-UB:

Use the checklist below to ensure the proper installation of the Embedded display:

1. All parts, tools and hardware in the package are accounted for.

2. Embedded display assembly is clear of any scratches or damage.

3. All screws are tightened down to their specified values.

4. Display's mounting bracket and back cover are properly mounted and secured.

5. All cables and harnesses are properly plugged into their respective connectors.

6. The front and back display plastics are properly installed and secured.

7. Cable feed and power adaptor are plugged into the front base of the unit.

8. Unit is leveled to the floor.

9.Touch screen responds to commands as specified in the User's Manual section regard-

ing the Calibration and Setup.

10. iPod® menu is functioning and user can browse and listen to music and videos.

11. TV is setup properly per the owner's manual, signal is clear and audio is coming from

both earphones.

ATTENTION

Star Trac recommends that the bikes be spaced a minimum of 20.0 inches (0.5 m) apart to allow

•

safe and easy ingress and egress. Even more importantly, there must be at least 48 inches

(1.25 m) of free space behind the bike.

As with any motorized equipment, the area where bikes are located must be free of obstructions

•

and fixtures with sharp edges to prevent injury in the event that a user trips or loses balance and

falls.

For technical assistance call Star Trac Customer Service: 1 800 503 1221

620-7922 Rev B