Star Trac E-UB Installation Instructions Manual page 25

Step 21.
Slide off and remove the CSAFE power connec-
tor from the old bottom plastic cover.
Step 23.
Install the new bottom plastic cover onto display,
use the screws saved from the earlier step to
secure the display bottom. Tighten the screws
so they are snug.
Note: Take special care to not pinch any of the ca-
bles between the plastics.
38
Step 22.
Install the CSAFE power connector on the new
bottom plastic cover.
Step 24.
Connect the CSAFE power cable from the bot-
tom cover to J10 connector on the display
board.
620-7922 Rev B