Star Trac E-UB Installation Instructions Manual page 44

Hide thumbs Also See for E-UB:

Screws

Step 9.

Remove the cap cover with the Star Trac logo

from the back cover plastics by removing the (2)

screws using a #2 Phillips screwdriver. Retain

screws for later use.

Note: You will no longer need the cap cover and, if

desired, you can store it away for any possible future

use.

Step 11.

Mount the PVS assembly on the mounting

bracket, then thread the (4) M8 button head

screws through the PVS mounting bracket into

the display mount. Do not tighten the screws

yet.

Screws

Step 10.

Remove the (2) M8 button head screws retain-

ing the cross-brace using provided 5mm Hex

key. Retain screws for later use.

Note: You will no longer need the cross-brace and,

if desired, you can store it away for any possible fu-

ture use.

Step 12.

Adjust the new cap with the grommet into place.

Then use the 5mm Hex key to secure the M8

button head screws holding the PVS assembly

in place.

Now secure the cap with the (2)

screws that were saved earlier.

620-7922 Rev B