Table of Contents
Advertisement
Trap Manager
The following menu allows the user to specify management stations that will receive authentication
failure messages or other trap messages from the switch. Up to 4 trap managers may be entered.
To set up trap receivers, define the following:
Trap Receiving Station
Community String
Status
The CLI commands used to manage trap receivers are
snmp
trap_receiver,
snmp
traps.
Using the Web-based Management Software
DES-7000/DES-7100 Layer 2 Switch User's Guide
Figure 6- 37. Trap Receivers Menu
Type in the IP address of the trap recipient, i.e. the IP address of the
management station that will receive traps generated by the switch.
Type in a string of up to 20 characters used for authentication of users
wanting to receive traps from the switch's SNMP agent.
Choose Valid or Invalid for the string. This is used to temporarily limit
the receipt of traps generated by the switch.
delete snmp
trap_receiver,
create snmp
trap_receiver,
disable snmp traps
config
and
enable
80
Advertisement
Table of Contents
