Snmp Trap Manager Setting - D-Link DES-5200 User Manual

Fast Ethernet Switching System User's Guide
Access Right
Enables you to set the access rights that members of the SNMP Communities
have. Read Only access rights mean that members of the community can view the
information on the DES-5200 but they can not make changes to the configurations.
Read/ Write access rights enable the members of the community to make any
changes they desire.
Status
Can be Valid or Invalid. Only communities with Valid status can access the DES-
5200. Communities with Invalid status cannot access the DES-5200.

SNMP Trap Manager Setting

Enables you to enter the IP address of Trap Managers. Traps are messages the
DES-5200 sends out to inform trap managers of events on the network. The DES-
5200 generates traps and sends them to the network manager. Trap managers are
special network users who are given certain rights and access to oversee and
maintain the network. This feature is available only in D-View or by using other
SNMP management software.
You can specify which network managers may receive traps from the DES-5200
by creating a list of IP Addresses of the authorized network managers.
Trap managers can receive the following trap types:
Cold Start
Signifies that the DES-5200 has been powered up. Software settings are
reconfigured and hardware systems are rebooted. A cold start is different from a
factory reset.
Authentication Failure
Signifies that an addressee (or manager/ user) on the DES-5200 is not a valid user
of the DES-5200 and may have entered an incorrect community name.
Link Change Event
Signifies that the link of a port has changed from link up to link down or vice
versa.
IP Address
This field is used to enter the IP Addresses of Trap Managers.
Managing the DES-5200
Cold Start
Authentication Failure
Link Change Event
76