Table of Contents
Advertisement
DES-7000/DES-7100 Layer 2 Switch User's Guide
Setup
The DES-7000 is shipped with the DES-7003 management module preinstalled. There are some
additional pieces that the user may opt to install. These are described below. The Quick Installation
Guide included with the switch contains illustrations and information that may be useful for installing
the additional hardware.
ake sure the location used is a suitable environment for the Switch and there is adequate ventilation.
M
Have the necessary cabling required to connect the Switch to the network.
You may install DES-7000 series network modules at any time before or after the switch has been
installed and powered on. Modules can be hot swapped to meet the changing demands of the network.
Attaching Wheels
The DES-7000 is shipped with four wheels that may
be install but are not required. To install the wheels,
gently place the chassis on either of its sides to
access the wheel mounts. Make sure the fan module
is firmly in place before tilting the chassis.
Each
wheel is held in place with four screws (included in
the package with the wheels).
Rack Installation
The chassis may be placed into a standard 19"
equipment rack with or without the wheels attached.
The ears at the front of both sides of the chassis
should be used to hold it firmly in place with screws.
Figure 2 - 2. DES-7000 Switch Chassis with optional wheels
Cable Bearer
The cable bearer is attached to the top of the chassis front panel on the DES-7000 chassis. Use the
four screws included in the packaging.
Unpacking and Setup
10
Advertisement
Table of Contents
