Table of Contents
Advertisement
The Port Group STP parameters that can be configured are:
State
Port Cost
Priority
By Pass
The relevant CLI commands for Port Group STP are
Forwarding and Filtering
Use these menus to setup Multicast and Unicast forwarding and MAC Address filtering.
For relevant forwarding and filtering CLI commands please read the section titled Layer 2 FDB
Commands in the CLI Reference Manual.
To configure the MAC address aging time used for the forwarding table, see Advanced Settings (page
52) for web-based configuration or use the CLI command
Static Unicast Forwarding
To add an entry, define the following parameters in the Add an Entry field:
VLAN ID
MAC Address
Allowed to Go to Slot
Port
The corresponding CLI commands for the Static Unicast Forwarding menu are
and
fdb,
clear fdb
Using the Web-based Management Software
DES-7000/DES-7100 Layer 2 Switch User's Guide
The STP State for the port or port group can be Disabled or Enabled. The
default setting STP State is Enabled.
A Port Cost can be set from 1 to 65535. The lower the number, the greater
the probability the port will be chosen to forward packets.
A Port Priority can be from 0 to 255. The lower the number, the greater the
probability the port will be chosen as the Root Port.
If you select No the forward delay timer is set to zero thus bypassing the
waiting time before the listening state. Default settings is Yes.
Figure 6- 18. Static Unicast Forwarding Setup
The VLAN ID number of the VLAN to which the above MAC address
belongs.
The MAC address to which packets will be statically forwarded.
Allows the designation of the module on which the above MAC address
resides.
Choose the port where the MAC address resides. Selecting Port 0 means
no ports are allowed.
show
fdb.
config stp_ports
config fdb
aging_time.
and
show
stp_ports.
create
fdb,
delete
65
Advertisement
Table of Contents
