Static Multicast Forwarding; Static Mac Address Filtering - D-Link DES-7000 User Manual

Static Multicast Forwarding

The following figure and table describe how to set up Multicast forwarding on the switch. Open the
Multicasting folder and click on the 802.1Q Multicast Forwarding button to see the entry screen below:
Use the Multicast Forwarding Screen to define the following parameters:
MAC Address
VID
Port Settings
The corresponding CLI commands for the Multicast Forwarding menu are
config multicast_fdb

Static MAC Address Filtering

Filtering based on MAC address is implemented globally for all ports.
Enter the unicast MAC address in the MAC Address field, and specify the Type from the drop-down
menu, choose Dst - Destination, Src - Source, or Either for a source or destination of packets.
Specifying a MAC address entry in the filtering table as a Destination will filter packets with this MAC
address as their destination. Source will filter packets with this MAC address as their source, and
Either will filter packets with this MAC address as either their source or destination.
The CLI commands used for MAC filtering are
fdbfilter.
Using the Web-based Management Software
DES-7000/DES-7100 Layer 2 Switch User's Guide
Figure 6- 19. Setup Static Multicast Forwarding Table
The MAC address of the static source of multicast packets.
The VLAN ID of the VLAN the above MAC address belongs to.
Allows the selection of ports that will be members of the static multicast
group and ports that are either forbidden from joining dynamically, or that
can join the multicast group dynamically, using GMRP. The options are;
None – no restrictions on the port dynamically joining the multicast group,
None is chosen, then an end station attached to the port can join the
multicast group using GMRP.
Egress – the port is a static member of the multicast group.
and
show multicast_fdb.
Figure 6- 20. MAC Address Filter Setup
create fdbfilter,
create multicast
delete fdbfilter
fdb,
and
show
66