Table of Contents
Advertisement
3
5
Load the desired size of paper to be adjusted on a tray, specify Punch, then press [Start] on the control
panel.
A sample pattern will be output.
6
Check the distance (a) from the edge of the feeding sheet to the center position of the punch hole.
7
If the desired result cannot be obtained, touch [ADJUSTMENT] tab.
The Paper Width Adjustment Screen will be restored.
8
Display the required size key using up/down arrow keys, and touch it.
9
Use the touch panel keypad to enter the desired adjustment value, then touch [<<SET].
Available range: -40 (wide) to +40 (narrow), 1 step = 0.1 mm
10
Repeat the adjustment steps from 4 to 9 until the desired result is obtained.
11
If adjustment in any other size is required, repeat steps from 4 to 10.
12
Touch [Return] to restore the Adjustment Menu Screen.
3-32
[1]
a
[2]
Adjustment
CS665 Pro
Advertisement
Table of Contents
