Table of Contents
Advertisement
11.1 Error Messages (EXXXX)
Error Code
E1050
The slot next to PRI card must be empty.
Please remove and re-assign the card that is installed next to a PRI card. A PRI card
must go into slot no. 1, 3, 5, 7, 9, 11 or 13.
E1051
E1 card should be assigned to the slot no. 1, 5 or 9.
E1 card should be assigned to the slot no. 1, 5 or 9 of basic shelf, expansion shelf 1 and
expansion shelf 2.
E1052
The slot next to E1 card must be empty.
Please remove and re-assign the card that is installed next to an E1 card. An E1 card
must go into slot no. 1, 5 or 9.
E1053
PRI card must be assigned to an odd numbered slot.
PRI card should be assigned to the odd numbered slot of basic shelf, expansion shelf
1 and expansion shelf 2.
E1054
The status of the card must be "OUS (Out-of-Service)."
When you change the card properties of E1, PRI30 or BRI card, the status must be
OUS (Out-of-Service)."
E2001
Invalid time format.
Please specify the time as Hour:[0]1-12, Minute:[0]0-59.
E2003
Invalid division of DAY and NIGHT mode.
Time to specify with Day 1, Night 1, Day 2 and Night 2 must be the relations of Day 1
< Night 1 < Day 2 < Night 2.
E2005
Maximum entry number of System Speed Dialing exceeded.
The system provides up to 1000/tenant, 2000/system of System Speed Dialling entries
available to all extension users.
E2006
Cannot change System Speed Dialing Entries Maximum.
Please delete System Speed Dialling entries until there is less than the setting you want.
Then set System Speed Dialling Entries Maximum once again.
E2007
Invalid directory number for manager extension.
Only DN of an extension can be assigned as a manager extension. (FDN cannot be
assigned.)
E2008
Feature number is too long.
Feature numbers "Hundred Block Extension" or "Other PBX" can be set as the leading
1 or 2 digits of the extension number.
E2009
Cannot delete the Hundred Block Extension, which is currently in use as DN or
FDN.
Cannot delete the hundred block number. It's already used as DN or FDN. Please delete
the hundred block number after you remove the registrations of DN or FDN.
274
Error Message
Description
Programming Error Messages
Advertisement
Table of Contents
