Table of Contents
Advertisement
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Group
PBX Access Code
Blank
1-4 digits consisting of 0-9,
Specifies the PBX access codes required to access the Host PBX or
Centrex service.
If the system is installed behind a host PBX or a Centrex system, an
access code is required to make an outside / Centrex call or to
access Centrex features.
Up to four codes can be assigned per Trunk Group.
• 1.3 System Features (F/G)
– Host PBX Access
• 2.8.2 If a Host PBX is Connected (U/M)
PBX Dial Tone
Disable
1.
Enable
2.
Disable
If enabled, the system sends a dial tone to the extension user who
seizes an E1 digital trunk line.
(Available for E1 digital trunk lines only.)
Notes
• In some countries, the E1 card must not be connected to the
Public Switched Network.
• In case of the E1 digital trunk line, the Central Office does
not send a dial tone to the caller.
• 1.3 System Features (F/G)
– E1 Carrier
3.2 Trunk Group
or #
109
Advertisement
Table of Contents
