Table of Contents
Advertisement
10. Exposure Trays
94MS42 Rev.B1 S/W Ver 2.06
Mylar® Replacement
•
Close the Mylar® frame and open the twelve cam latches.
•
Remove the inner Mylar® frame and position a pre-cut Mylar® sheet
into the frame. Make sure that the Mylar® is overlapping on all sides.
•
Reinstall the inner Mylar® frame and ensure all cam latches are closed.
•
Trim the excess Mylar® from between the inner and outer frames.
If Mylar® Pulls Out of the Frame.
•
Make sure the Mylar® is not cut too small. The Mylar® must overlap
on all sides so that it comes up between the inner and outer frames. Mark
on the Mylar® where the cam latches are and cut a small slit in the mylar
to allow the cam latches to lock down. Then trimmed off once the inner
frame has all the cam latches in the closed position.
•
Make sure the inner and outer frames are not bent or damaged, if so,
replace them.
Outer Frame Replacement
•
Remove the inner frame.
•
Open the frame then remove the safety clips from the gas shocks.
•
While holding the frame up pull the gas shocks off of the mounting ball
joints then lower the frame.
•
Remove the 2 Allen screws from each of the four hinges in the back of
the frame and lift the frame off.
Note: The frame MUST be squared when it is reinstalled.
Closed
Position
Open
Position
Cam Latch
10-1
Advertisement
Table of Contents
