Table of Contents
Advertisement
!
C Verify the adjustment by noting the position of the frame when it is inside
94MS42 Rev.B1 S/W Ver 2.06
Press the 6 key again: upper tray should move in, the vacuum window
•
should read [ 0 096] .
•
Set Volt meter for VDC and measure across pins 5 & 6 on motor speed
connector. Adjust the 'SLOW' pot on the control box to read 25 to 32
VDC. Notice that the frame moves slower than normal. The total travel
time of the frame should be 12 seconds.
•
Exit the diagnostic mode by pressing the 9 key then the 0 key.
•
Adjust the 'FAST' pot on the control box.
•
Press and hold the 'STOP' key then press the 'GO' key and then release
both keys to start a blank frame cycle, no vacuum or exposure.
•
Measure across pins 5 & 6 on motor speed connector. Adjust the 'FAST'
pot on the control box to read between 70 and 84 VDC. The frame should
travel at high speed for about 4.5 seconds, then shift to a slower speed
and stop about 0.750" (19mm) to 1" (25mm) from the end of the tray
rod.
the Unit. Check the frame position switches for each frame.
When adjusted properly, the frame will come to a stop
depressing the first switch, but not the second. If the second
switch is depressed, check slow speed adjustment.
SET SELECT SWITCH TO
SLOW
FAST
LINE UP WITH
SPEED
MOTOR
COMMUNICATION
LED INDICATOR LIGHT
STOP
SLOW
OUT
IN
LINE VOLTAGE
SELECTION
MOTOR
VACUUM
A/C
ACCESSORY
L - SWT
PUMPS
SWITCH
12VDC
6
4
AUX
3
1
J21
GTOOL
POWER SUPPLY
POWER SUPPLY
HF1 BLOWER
HF1 BLOWER
11-5
Advertisement
Table of Contents
