Table of Contents
Advertisement
3.
Integrator Functions and Features
[ 3 9]
[ 0 120]
[ 0 34. 5 ]
P
[ 0 0] Y
[ 0 000] V
[ 0 000] e
I
D
F
T
U
m
7
8
9
4
5
6
1
2
3
0
0
1
2
3
4
5
6
7
8
9
94MS42 Rev. B1 S/W Ver. 2.06
Microprocessor-controlled light integrator with LED display, 40
memories, battery backup, single button control, lamp statistics and self-
diagnostics. The operator control panel is composed of two sections, the
display board and the memory board.
Note: The number of digits in each window.
Memory Window
Vacuum Window
Exposure Window
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Integrator
P
POWER
Press the power button on the integrator to turn the AP 42CL on or off.
When the unit is off, the light system blowers will run for about two
minutes to cool the lamp.
Y
MEMORY
Pressing the memory key will advance the memory location. The display
will show which memory is selected.
V
VACUUM
Press the vacuum key and use the numerical keypad to enter a vacuum
delay time. The window shows the delay in seconds.
e
EXPOSURE
Press the exposure key and use the numerical keypad to enter an exposure.
The window shows the exposure units selected. This key can also be
used to move forward through the selectable features in the setup mode.
I
INTENSITY
Press this key to select Low, Medium or High power. LEDs lit will
indicate the level selected.
D
DIFFUSER
Press this key to select the motorized diffuser option.
F
FILTER
Press this key to select the motorized filter option.
T
SECONDS
Press this key to expose by time, not integrated light units. This key also
can be used to move backward through selectable features in the setup
mode.
3-1
Advertisement
Table of Contents
