Table of Contents
Advertisement
!
C The default tray speed is set at the factory to 5 seconds. OLEC does not
[ S EL_]
[ t rAY]
!
[ S EL_]
[ t YPE]
[ A P30]
4-8
Tray Mode
recommend changing this setting without consulting the
OLEC factory. Damage to the transport can occur.
Press the P key on the integrator to power up the light, the front remote
•
switches, and the exposure unit's computer system.
Press 1,2,3t 4 in sequence. The Vacuum window will read
[ S EL_] . This places you in the select mode.
Press the Y key once. The Memory window will read [ S u] .
•
Press the e key until [ t rAY] appears in the Exposure window.
Press the V key once. The Vacuum window will read [ - ---] and the
•
Exposure window will read [ c odE] . If lock mode was turned ON, enter
your code now, then press the V key, (If the lock code has never been
changed section 4.3, the default code is 000).
•
Enter the time you wish to have the tray speed set for. For example, for a
5.0 second travel time, press 5,0 and then press the V key again the
Memory window and Exposure window will return to normal brightness.
Press the 0 key twice to exit this mode.
•
Type Mode
C The type has been set at the factory and should not be changed.
Proper operation of the unit will be affected if changed.
Press the P key on the integrator to power up the light, the front remote
•
switches, and the exposure unit's computer system.
Press 1,2,3t 4 in sequence. The Vacuum window will read
[ S EL_] . This places you in the select mode.
Press the Y key once. The Memory window will read [ S u] .
•
Press the e key until [ t YPE] appears in the exposure window. This places
you in the System Type option.
Press the V key once. The Vacuum window will read [ - ---] and the
•
Exposure window will read [ c odE] . If lock mode was turned ON, enter
your code now, then press the V key, (If the lock code has never been
changed, the default code is 000).
Press the V key to cycle the Vacuum window to read [AP30]. This setting
applies to both the AP30 5kW and AP30 8kW, air conditioned and closed
loop models.
Press the 0 key twice to exit this mode.
•
94MS42 Rev. B1 S/W Ver. 2.06
Advertisement
Table of Contents
