[ S EL_]
[ c odE]
!
C This step clears all lamp statistics explained in sections Lamp Statistics.
[ S EL_]
!
C This step clears all information stored in the memory.
94MS42 Rev. B1 S/W Ver. 2.06
Setting or Changing your Lock Code feature
Note: If you are setting the code you must know the existing code.
Note: Lock Level must be set to 0 to program this step and reset when
finished see Lock Level feature.
Press the P key on the integrator to power up the light, the front remote
•
switches, and the exposure unit's computer system.
Press 1,2,3t 4 in sequence. The Vacuum window will read
[ S EL_] . This places you in the select mode.
Press the Y key once. The Memory window will read [ S u] .
•
Press and release the e key until the Exposure window reads [ c odE] .
Press the V key the Memory and Exposure windows will dim. Enter
•
your new 3 digit code
Press the V key to set entry.
•
Press the 0 key twice to exit this mode.
•
To Clear Lamp Statistics
Note: You can abort clearing the lamp statistics by pressing the 0 key
before the display counts down to [ S EL_] and you will not change
any memory and exposure statistics.
Note: Lock Level must be set to 0 to program this step and reset when
finished, see Lock Level feature.
Press the P key on the integrator to power up the light, the front remote
•
switches, and the exposure unit's computer system.
Press 1,2,3t 4 in sequence. The Vacuum window will read
[ S EL_] . This places you in the select mode.
Press the 7 key five (5) times.
•
Press the 0 key once to exit this mode.
•
To Clear Memory and Exposure Statistics
Note: You can abort clearing the memory by pressing the 0 key before
the display counts down to [ S EL_] and you will not change any
memory and exposure statistics.
4-3