Table of Contents
Advertisement
!
!
!
94MS42 Rev. B1 S/W Ver 2.06
C Turn the shutter only counterclockwise (looking from the
motor end) or you may damage the shutter switch on the other
end of the light.
•
Remove the chain from the sprocket with care to keep tension. The chain
has shortened links and will separate if slackened. If the chain opens,
attach an end to the sprocket with tape or wire and revolve the shutter.
•
Remove the motor sprocket by loosening the set screw.
•
Remove the two wire nuts from the motor coil wires.
•
Remove the four motor screws.
Installing the Motor
•
Mount the motor with four screws.
•
Install the sprocket in line with the shutter sprocket and tighten.
•
Install the chain on the sprockets.
•
Set the chain to where it has
motor screws lightly.
C Turn the shutter only counterclockwise (looking from the
motor end) or you may damage the shutter switch on the other
end of the light.
•
Rotate the sprocket to tighten the other two screws and attach the wires.
•
The shutter can be tested with the unit open by disconnecting one of the
lamp leads and holding the interlock switch.
C DO NOT light the lamp without the safety glass or when
you are close to the bulb.
3
/
" side travel and tighten the two accessible
8
13-11
Advertisement
Table of Contents
