Table of Contents
Advertisement
2.
Cooling System
!
94MS42 Rev.B1 S/W Ver 2.06
Connecting the Evaporator
•
Place the evaporator flat on the floor.
•
Connect the hose from the evaporator to the bottom of the rear panel
drain.
Cl Make sure the hose end on the evaporator is lower than
the bottom of the rear panel drain or moisture will collect in
the bottom of the Closed Loop System.
Evaporator
•
Attach the plate to rear of cabinet. Connect it to the 3 pin connector P63
marked "Evaporator" provided inside the unit.
Note: The evaporator is ON when the machine is ON.
•
If the fan in the evaporator does not come ON when the machine is turned
ON, unplug the electrical connector P8 on the evaporator and check with
a voltage meter the P8 connector between pins 1 & 2 for 240V~.
If voltage is present and the blower is not running replace the blower.
If voltage is not present, go to the control box and unplug the J12 connector
and measure for 240V~ between pins 3 & 4 on the board. If voltage is
present, there is a break in the cable from the board to the evaporator and
it needs to be replaced. If there is no voltage, replace the 64CT464 PCB
in the Control Box.
Feed for Evaporator
Power Cord
Drain Hose to
Evaporator
2-1
Advertisement
Table of Contents
