Table of Contents
Advertisement
94MS42 Rev.B1 S/W Ver 2.06
Work Lights
Note: The work lights are controlled by a rocker switch on the underside
of the right front corner of the nose cover.
Note: If the work lights are not turning ON, check the rocker switch
and power to the switch.
Note: The work lights receive their power from the autoformer in the
nose section
•
To change the lamps the trays must first be moved to the center position.
This is done by:
Press and hold the S button.
•
Press the G button.
•
•
Release both buttons when trays start moving.
•
Just before the trays reach the center turn the power OFF.
•
Lift the diffusion cover off of the light assembly.
•
Twist the lamp to disengage it from the socket and remove it.
•
Install in reverse order.
Nose Fans
Note: The nose fans are controlled by a rocker switch on the underside
of the right front corner of the rail cover.
Note: If the nose fans are not turning ON, check the rocker switch and
power to the switch.
•
Remove the nose.
•
Disconnect the power leads to the blower(s).
•
Remove the blower(s).
•
Install in reverse order.
Cleaning or Replacing Nose Filters
•
Slide the filters toward the front of the unit and out of the brackets.
•
Clean metal filters with water or environmentally safe solvent.
9-3
Advertisement
Table of Contents
