Table of Contents
Advertisement
9-2
•
Use a small screw driver inserted between the switch and the sheet metal
to break the glue holding the two black retainer clips on each side of the
switch from the rail cover.
•
Press together the switch retainer clips on the base of the switch and
push the switch out through the top. Replace wire for wire onto the new
switch.
•
Install in reverse order. Put a drop of super glue on each retainer clip to
hold it to the rail cover.
Replacing the Glass Tool Vacuum Buttons
•
Remove the left rail cover and place it on carpet or any surface that will
not damage the paint. (see Nose Assembly Left and Right Covers)
•
Disconnect and mark the wires on the back of the switch base.
•
Remove the two screws from the bottom of the switch base.
•
While holding the top of the button unscrew the switch base to separate
the switch in two pieces and remove it from the rail cover.
•
Install the new switch in reverse order.
Replacing the Vacuum Gauges
•
Remove the right rail cover and place it on carpet or any surface that will
not damage the keypad overlay or the paint. (see Nose Assembly
Drawings)
•
Remove the vacuum tubing from the gauge.
•
Remove the gauge retaining bracket and the faulty vacuum gauge.
•
Install in reverse order.
Nose Section Autoformer
Note: The work lights and nose fans receive their power from this
autoformer, if both the fans and the work lights are not working
check this autoformer first.
•
Remove the right and left rail covers and place them on carpet or any
surface that will not damage the keypad or the paint. (see Nose Assembly
Left and Right Covers)
•
Remove the twelve #10 - 32 x 1/2 Soc. button head screws (see Base
Assembly Diagram DETAIL H).
•
Slide cooling compartment out to get access to the autoformer
•
Meter input and output of the autoformer from 0 to 240V, 0 to 208V and
0 to 120V. If defective replace.
94MS42 Rev.B1 S/W Ver 2.06
Advertisement
Table of Contents
