Exposure Statistics (Elapsed Hours); Exposure Statistics (Total Exposures) - Accuprint AP42CL 8000 Service Manual

[ S EL_]
[ L E__]
[ t ot_]
[ t Cr_]
[ t Lo_]
[ t Hi_]
[ S EL_]
94MS42 Rev. B1 S/W Ver. 2.06

Exposure Statistics (Elapsed Hours)

Note: The exposure statistics should be reset to zero when the lamps
are changed.
Note: This provides the operating hours on the lamps in total and at
each intensity since the last reset. This function should be used
whenever the exposure lamps are replaced.
Press the P key on the integrator to power up the light, the front remote
•
switches, and the exposure unit's computer system.
Press 1,2,3t 4 in sequence. The Vacuum window will read
[ S EL_] . This places you in the select mode.
Press the 1 key. The letters [ L E__] will appear in the Vacuum window.
The Exposure window will display the exposure time, in seconds, of the
last exposure, regardless of its memory position or intensity.
Press the 1 key a second time, the letters [ t ot_] will appear in the
Vacuum window. The total elapsed time, in hours, that the unit has been
ON will be displayed in the Exposure window.
Press the 1 key a third time. The letters [ t Cr_] will appear in the Vacuum
window. The elapsed time, in hours, that the lamp has been used at
medium power will show in the Exposure window.
Press the 1 key a fourth time. The letters [ t Lo_] will appear in at the
Vacuum window. The elapsed time, in hours, that the lamp has been
used at low power will show in the Exposure window.
Press the 1 key a fifth time. The letters [ t Hi_] will appear in the Vacuum
window. The elapsed time, in hours, that the lamp has been used at high
power will show in the Exposure window.
Press the 0 key twice to exit this mode.
•

Exposure Statistics (Total Exposures)

Note: To find out how many exposures your system has made since the
last reset.
Note: The exposure statistics should be reset when the lamps are
changed.
Press the P key on the integrator to power up the light, the front remote
•
switches, and the exposure unit's computer system.
Press 1,2,3t 4 in sequence. The Vacuum window will read
[ S EL_] . This places you in the select mode.
4-9