Table of Contents
Advertisement
9-2
Replacing the S and G Buttons
•
Slide the nose out (see section Removing the Nose) but it is not necessary
to completely remove it, the nose just needs to be slid out far enough to
access the switches.
•
Use a small screw driver inserted between the switch and the sheet metal
to break the glue holding the two black retainer clips on each side of the
switch from the nose.
•
Press together the switch retainer clips on the base of the switch and
push the switch out the top and replace wire for wire onto the new switch.
•
Install in reverse order, Put a drop of super glue on each retainer clip to
hold it to the nose.
Replacing the Glass Tool Vacuum Buttons
•
Remove the nose (see section Removing the Nose) and place it on carpet
or any surface that will not damage the keypad overlay or the paint.
•
Disconnect and mark the wires on the back of the switch base.
•
Remove the two screws from the bottom of the switch base.
•
While holding the top of the button unscrew the switch base to separate
the switch into two pieces and remove it from the nose.
•
Install the new switch in reverse order.
Replacing the Vacuum Gauges
•
Remove the nose (see section Removing the Nose) and place it on carpet
or any surface that will not damage the keypad overlay or the paint.
•
Remove the vacuum tubing from the gauge.
•
Remove the gauge retaining bracket and the faulty vacuum gauge.
•
Install in reverse order.
Nose Section Autoformer
Note: The work lights and nose fans receive their power from this
autoformer, if both the fans and the work lights are not working
check this autoformer first.
•
Remove the nose (see section Removing the Nose)
•
Meter input and output of the autoformer from 0 to 240, 0 to 208 and 0 to
120. If defective replace.
94MS41 Rev. C1 S/W Ver 2.06
Advertisement
Table of Contents
