ITT HT 3196 i-FRAME Installation, Operation And Maintenance Manual page 100

Goulds pumps
Table of Contents

Advertisement

Maintenance
11. Prepare the shaft for assembly as follows (see the illustration):
a) Fasten the clamp-ring bolts (236A) crosswise.
b) Install a new O-ring (496).
c) Install the outboard labyrinth oil-seal (332A) into the bearing housing (134).
12. Install the shaft assembly into the bearing frame as follows (see the illustration):
a) Coat the outside of the bearing housing (134) with oil.
b) Coat all the internal surfaces of the bearing frame (228) with oil.
c) Install the shaft assembly into the bearing frame (228).
d) Install the clamp bolts (370C) in the bearing housing (134) and tighten by hand.
e) Install the jack bolts (370D) with the locknuts (423) in the bearing housing (134) and tighten by
98
134
See the specified torque values.
Make sure that the shaft rotates freely.
Place the drain slots of the oil seal at the bottom position (6 o'clock).
Make sure that the edges of the keyway are free from burrs. To protect the O-ring, cover the
keyway lengthwise with a piece of electrical tape before you install the oil seal.
253B
134
332A
Make sure that the shaft rotates freely.
hand.
134
423
370D
370C
Model HT 3196 i-FRAME Installation, Operation, and Maintenance Manual
236A
496
228A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HT 3196 i-FRAME and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents