Page 1
Bell & Gossett ® Instruction Manual S14362 Glycol Make-up Unit Installation, Operation and Maintenance Instructions INSTALLER PLE SE LE VE THIS M NU L FOR THE OWNER’S USE. S FETY DESCRIPTION INSTRUCTIONS Single pump unit provides pressurized water or water-glycol This safety alert symbol will be used in this manual and on the mixture to a closed-loop: heating, chilled water, snowmelt, Safety Instruction decal to draw attention to safety related...
ITT Bell & Gossett 3530 Pump – http://fhasapp.ittind.com/literature/files/644.pdf B. ITT Goulds HMS Pump – http://www.goulds.com/pdf/IM083R02.pdf C. ITT Bell & Gossett Expansion Tank – http://fhasapp.ittind.com/literature/files/927.pdf D. ITT McDonnell & Miller Low Water Cut-Offs Switch – http://fhasapp.ittind.com/literature/files/1446.pdf SQU RE D Pressure Switch – http://ecatalog.squared.com/pubs/Machine%20Control/Condition%20Sensors/ Pressure%20Switches,%20Water%20and%20 ir/9013F/65013-005-39F.pdf...
Section 1 GENER L DESCRIPTION H NDLING The Glycol Make-up unit is designed to automatically Care should be taken to prevent damage due to maintain minimum pressure in closed-loop systems. dropping or jolting when moving the Glycol Make-up The GMU-30 uses 1/2 HP pump for systems requir- Unit.
See drawing 1FC008 for location of valves. F ILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PROPERTY D M GE ND/OR MODER TE IMPORT NT: Do not install and operate ITT pumps PERSON L INJURY. in closed systems unless the system is constructed with properly sized safety devices and control devices.
Section 3 PUTTING THE UNIT INTO SERVICE W RNING: Electrical shock hazard. Disconnect and lockout power before servicing the unit. F ILURE TO C UTION: Prevent subsequent damage. unit show- FOLLOW THESE INSTRUCTIONS COULD RESULT IN ing symptoms of possible problems (noise, leaks, SERIOUS PERSON L INJURY, DE TH, ND/OR PROP- vibration, and/or continual operation) must be corrected...
ppendix ppendix B SYSTEM PIPING ND UNIT ELECTRIC L WIRING ND CONTROL INST LL TION – FIN L CHECK LIST SETTINGS – FIN L CHECK LIST ____ 1. Is the unit base properly leveled and secured? ____ 1. Does the feeder line voltage correspond to the unit voltage? Check the unit nameplate or motor terminal ____ 2.
ppendix C – Troubleshooting Pump will not start automatically D NGER: Troubleshooting live control panels ex- poses personnel to hazardous voltages. Electrical W RNING: Electrical shock hazard. Inspect all troubleshooting must only be done by a qualified electri- electrical connections prior to powering the unit. cian.
Need help?
Do you have a question about the Bell & Gossett GMU-30 and is the answer not in the manual?
Questions and answers