Configuring Ntp Server Authentication - Foundry Networks NetIron M2404C User Manual

Foundry NetIron M2404C and M2404F Metro Access Switches
Starting the NTP Server Polling
The time-server ntp start command, in Global Configuration mode, starts the NTP server polling.
NOTE
Command Syntax
device-name(config)#time-server ntp start <polling-interval> <zone>
Argument Description
polling-interval
zone
Displaying the NTP Servers
The time-server ntp show command, in Global Configuration mode, displays the IP addresses of
the currently defined NTP servers.
Command Syntax
device-name(config)#time-server ntp show
Example
The following example displays the three existing NTP servers:
device-nameconfig)#time-server ntp show
186.102.20.11
182.21.2.31
128.11.24.6

Configuring NTP Server Authentication

Table 28 lists the NTP Server authentication commands.
Table 28: NTP Server Authentication Commands
Command
time-server ntp key add
time-server ntp key delete
time-server ntp key show
Managing the System Time and Date
To end the NTP server polling use the command no time-server in Global
Configuration mode.
The synchronization refresh period in minutes, in the range <10-44640>
(the upper limit is equivalent to 31 days).
Shift of local hour relative to GMT (positive East, negative West of
Greenwich). The range is -12 to 12.
Description
Adds authentication key.
Deletes authentication key.
Displays existing NTP keys.
© 2008 Foundry Networks, Inc.
Switch Administration (Rev. 03)
Page 68 of 87