Table of Contents
Advertisement
Foundry NetIron M2404C and M2404F Metro Access Switches
Getting Started with the CLI
The device is configured through a VT-100 (or compatible terminal) connected to the Console port
in the front panel.
The CLI operates automatically when the user turns on the device. Before the user starts using the
CLI command facility, the user must proceed as follows:
1.
Attach an RS-232 ASCII terminal to the Console port located on the front panel.
2.
Configure the terminal to operate at:
3.
Establish a session with the unit and turn on the unit. After a few seconds, the terminal
screen displays output similar to the following:
Foundry Networks Boot Loader
Switch model
Loader version : 1.0.0 created Jan 22 2007 - 17:04:28
MAC Address
Press any key to stop auto-boot...
0
auto-booting...
Starting switch application, please wait...
BUILT-IN SELF TEST
------------------
CPU Notify RAM Test
CPU Interface Test
Testing Switch Core
Data Buffer Test
Power Supply Test
On-board Power Test
Fan Test
Getting Started with the CLI
o 9600 bps
o 8 data bits
o 1 stop bit
o No parity
o No flow control
o 25 lines and 80 columns window size.
: NetIron M2404C
: 00:12:F2:87:F0:0B
: Passed
: Passed
: Passed
: Passed
: Passed
: Passed
: Passed
© 2008 Foundry Networks, Inc.
Using the Command Line Interface (Rev. 03)
Page 3 of 12
Advertisement
Chapters
Table of Contents
