Configuring Static Routes; Creating A Static Route - Foundry Networks NetIron M2404C User Manual

Foundry NetIron M2404C and M2404F Metro Access Switches
Parameter
Debug Router Manager
Processing LSRR packets
Table 2: The Default Administrative Distances of the Dynamic Routing Protocols
Route Source
Connected IP interface
Static route
OSPF
Unknown

Configuring Static Routes

Table 3 lists the static routes commands.
Table 3: Static Routes Commands
Command
ip route
redistribute static
show ip route
ip arp
clear ip arp

Creating a Static Route

The ip route command, in Global Configuration mode, defines a static route. The no form of this
command removes the specified static route.
If the user does not need to forward the traffic to specific destinations without match, the user can
apply a less specific route entry to the NULL device. To globally disable the gratuitous forwarding
for destinations that are missing from the routing table, the user can apply a default routing entry to
the NULL device.
By default, the administrative distance is 1.
Command Syntax
device-name(config)#ip route {destination-address netmask |
destination-prefix} {A.B.C.D | null} [<distance>]
device-name(config)#no ip route {destination-address netmask |
destination-prefix} {A.B.C.D | null} [<distance>]
Configuring IP Unicast Routing
Default Distance
0
1
110
255
Description
Defines a static route.
Advertises the static routes.
Displays the configured static routes.
Adds a static ARP entry.
Removes the dynamic and static entries learned in the ARP table.
© 2008 Foundry Networks, Inc.
Configuring Routing Information (Rev. 03)
Default Value
Disabled
Enabled
Page 6 of 48