Starting The Ipecs Emg80; Ipecs Emg80 System Initial Power-Up - iPECS eMG80 Installation Manual

iPECS eMG80
Hardware Description and Installation Manual
S
8. TARTING THE iPECS eMG80

8.1 iPECS eMG80 System Initial Power-up

The eMG80 incorporates software initialization routines to automatically configure system
gains and tones based on the Nation Code assigned in the system database. The Nation
code is the Country code used for international dialing. Generally, this will be properly set
but, prior to any other configuration, the Nation Code must be verified to match the location
of the installation. If not it can be modified and the system initialized with the modified
Nation Code.
To initialize the system, perform the following Steps:
1. Verify the KSU MBU SW1 pole#1 is OFF, and pole#2 is ON. Also verify the AC
Power switch is OFF.
2. Plug the AC power cord into the iPECS eMG80 System KSUs and the AC outlet.
3. Turn the AC Power switches on the KSU and EKSU ON.
4. Verify and, if needed, modify, the Nation Code (PGM100) with the DKT (Section
8.2.1) or run the Install Wizard (Section 8.3).
5. Reset the KSU with either the recessed Reset button or by power cycling (turn the
AC Power switch OFF then ON).
6. After KSU MBU LEDs indicate normal operation, refer to section 4.5 and change the
position of the KSU MBU SW1 pole#1 to the OFF position so the database will not
initialize during future power cycling or if the system is reset.
7. If the DKT was used to set the Nation code in Step 4, run the Install Wizard then
configure the system to the customer needs.
The following sections detail how to verify and change the Nation Code and run the Install
Wizard. Once the Nation Code has been set and the system database initialized, the system
can be configured without the need to reinitialize. For detailed information on configuring the
eMG80 system, refer to the eMG80 Administration and Maintenance Manual.
90
Issue 1.0