Bh104 (1Bri And 4 Hybrid Interface Board) - iPECS eMG80 Installation Manual

iPECS eMG80
Hardware Description and Installation Manual
LED Indications

4.7.4 BH104 (1BRI and 4 Hybrid Interface Board)

Description
The BH104 board has one (1) BRI (2B+D) and 4 Hybrid (DKT & SLT) interface ports. The
board, shown in
There are no option boards for the BH104.
Multiple pole Dip-switches determine the operating mode 'S' or 'T' and termination.
The board is provided with two Standoffs that must be installed prior to mounting the board.
To install the board in the KSU, refer to Section 4.4.
Connector and Modular jack
Table 4.7.4-1 Connector and Modular Jack Function
Connector
CN1
CN2
CN3
MJ1
MJ4
Table 4.7.3-2 CS416 LED Indications
LED Color
LD1 Blue Station port in use status
ON – A station port is in use
OFF – All station ports are idle
Figure 4.7.4-1, can be installed on the CN1 connector of only the KSU.
Figure 4.7.4-1 BH104
Connection to second Interface board
Connection to CN1 connector of MBU
CPLD JTAG for development
1 BRI (2 B+D)
4 DKT or SLT line
Description
Functions
44
Issue 1.0
Remark
70 pins
70 pins
10 pins
RJ45
RJ11