Lip-8000E Wall Mount - iPECS eMG80 Installation Manual

iPECS eMG80
Hardware Description and Installation Manual

7.4.2 LIP-8000E Wall Mount

The LIP-8000E series phones incorporate wall mount into the base of the phone housing.
Using the instructions, mount the LIP-8000E series phone on the wall. An LIP phone with
Consoles can be Wall Mounted after the Console is properly connected to the LIP phone,
refer to section 7.3.4.
1. Using Figure 7.4.2-1 Mark and drill two (2) 7mm holes for plastic wall anchors.
2. Insert the two (2) anchors into the holes and insert and tighten the 2 screws leaving
about 2.5 mm (1/8-inch) exposed. If installing an LIP phone with a Console, also drill
anchor holes and insert and tighten screws for the Console Wall Mount slots.
3. Slide the LIP-8000E phone over the screws and assure the phone is secure. It may
be necessary to remove the phone and tighten or loosen the screws for a secure
mounting.
4. Remove the Handset hook from the phone as shown in the figures below. Reverse
the hook and re-install in the LIP-8000E phone so that the hook catches the groove
in the handset receiver.
Figure 7.4.2-1 LIP-8000E Series Wall Mount Installation
89
Issue 1.0